Radio Transmitter

For your comments, suggestions, or your looking for a circuit or design, or a electronics designer, please send you Inquiries to We are happy to help and attend to your concerns.

Wednesday, April 1, 2009

Self-powered Sine to Square wave Converter

Converts sine to square waves without a power-source
Useful as a test instrument for audio purposes

This circuit is intended to provide good square waves converting a sine wave picked-up from an existing generator. Its main feature consists in the fact that no power-source is needed: thus it can be simply connected between a sine wave generator and the device under test.

The input sine wave feeds a voltage doubler formed by C1, C2, D1 & D2 that powers the IC. IC1A amplifies the input sine wave, other inverters included in IC1 squaring the signal and delivering an output square wave of equal mark/space ratio and good rise and fall times through the entire 20Hz-20KHz range.

  • R1_____________1M 1/4W Resistor
  • R2___________100K Linear Potentiometer
  • C1,C2________100µF 25V Electrolytic Capacitors
  • C3____________10nF 63V Polyester Capacitor
  • D1,D2_______1N4148 75V 150mA Diodes
  • IC1___________4069 Hex Inverter IC
  • Best performances are obtained with an input sine wave amplitude from 1V RMS onwards.
  • Output square wave amplitude is proportional to input amplitude.
  • Minimum sine wave input amplitude needed for good performance: 750mV RMS.
  • Output square wave amplitude with 1V RMS input: 3V peak to peak, with R2 set at max.
  • Minimum output square wave amplitude: 2V peak to peak, with R2 set at max.
  • Substituting the two silicon diodes with germanium types (e.g. AA118, AA119), the minimum input threshold can be lowered.

No comments:

Post a Comment